Product Details

1. Standard configuration

One piece of leather pad, four pieces of imported blade (excluding the blade in the sampling knife)

2. Instructions:

(1) Lay the fabric to be cut on the rubber mat, place the disc sampler on the fabric, pull out the lock on the sampler, rotate about 90 degrees, hold the cover with one hand, and hold the corrugated handwheel with the other hand. Apply a certain pressure and then rotate the corrugated handwheel clockwise (the angle is greater than 90 degrees) to cut the round specimen.

(2) after the sampler is used, the locking device is rotated to the original position, so that the blade can not be exposed, so as not to hurt the hand and other items.

3. Structure and Adjustment

(1) The cutter blade has four pieces for the double-sided blade. The outer blade is evenly distributed in four equal parts. The blade can be replaced. The specific operation is as follows: loosen the Phillips screw (four screws on each piece), remove the blade pressure plate and the sampling blade. Replace the new blade and press the blade pressure plate. Make sure that the blade opening is clockwise and the four blades are in the same plane. Then tighten the Phillips screw.

(2) the bottom of the instrument has straight lines and is used to fix the sample, which is easy to cut and prevent the sample from slipping.

4. Precautions:

(1) The blade of this instrument has sharp edge and should not be placed on the bottom during use to avoid damage.

(2) The instrument cutting sample should be carried out on the rubber mat, wipe the instrument when not in use, put it in the instrument box to avoid damage.